Troubleshooting - Kunft KDM2739 Manual De Instrucciones

Cleaning the cabinet and the inner tube
Use a soft damp cloth when cleaning the
cabinet and the inner tube.
1. Do not directly rinse with water.
2. Do not use a neutral scouring agent.
3. Not to use gasoline or alcohol.
Make sure you open the front door for aeration
when cleaning the inner tube.
Safety reset
1. These dryers have a safety cut out switch which is activated by
temperature.
2. The safety reset button is on the backboard. If your dryer is not
heating, this button must be pressed before the dryer will operate
again. You may need to wait 10 minutes for cooling to take place.
3. The most common reason for the dryer to overheat is a blocked
filter.
Clean the lint filter after each load to prevent the dryer from
overheating.
It will only be necessary to press the safety reset button if the
dryer is not heating. Allow the dryer to cool down for at least 10
minutes before pressing the button. Press the white button in until
you feel the reset click. Cleaning the filter after each load will avoid
repetitive use of the safety cut out switch.
The cut out switch may be activated in the following cases:
1. The lint filter is blocked.
2. The exhaust outlets at the back of the dryer are blocked.
3. Poor ventilation in the room - open a window or a door
4. A lightweight garment e.g. handkerchief has been sucked onto
the filter.
Safety Reset Button
Use your finger or a pencil to press the button in until you feel it click.
18
vented tumble dryer

2.4. Troubleshooting

Problem Cause
The dryer • Power cut
won't start
• The power plug is
not fully plugged in
• Excessive load.
• The temperature
fuse cut out.
The dryer • The lint filter is dirty.
is hot to the
• The uptake or
touch or
exhaust duct is dirty
smells hot
Clothes are • The dryer is too full
too dry
• The clothes
weren't removed
immediately after
the programme
ended
• The clothes don't
assort properly.
• Too high a
temperature was
used.
Shrunken • Too dry.
clothes
Hairballs on • It is common for
clothes synthetic fibre or
crease resistant
fibre garments to
produce hairballs
due to friction.
EN
KDM2739
Solution
• Wait for power to be
restored
• Check the power
socket, make sure it is
fully plugged in.
• After spinning and
drying, the weight of
clothes in the dryer
cannot exceed 7kg.
• Request the services
of a qualified person to
replace the fuse.
• Clean the lint filter
immediately.
• Clean out the stem.
• Ensure the dryer isn't
too full.
• Remove the clothes
from the dryer
immediately after the
programme ends.
• See page 7.
• Observe the care label
on clothes.
• Observe the care label
on clothes. If these
shrink easily, inspect
them when dry. Remove
the clothes from the
dryer when they are still
a bit damp and line dry
them.
• Use a fabric softener.
Please spray settled
gule on cuffs and
necklines when ironing
clothes. Turn sarsenet
inside out to reduce
friction.
19