Lenco LBT-188 Manual Del Usuario página 8

Please check thoroughly and make sure you find the following items that
come along with this package:
1) Unit
2) Adaptor with EU-UK plug-end
3) Counterweight
4) Platter with Belt
5) 45 RPM Adaptor
6) Turntable mat
This turntable is supplied with a factory fitted and adjusted cartridge.
**The following instructions for adjusting the cartridge are provided in case
the cartridge is replaced by a different model at a later date.
Installing the Lid
Install the Lid carefully over the hinge prongs.
Turntable Platter and Belt Setup
1. Install the drive belt over the inner ring under the platter and make sure
it won't fall off during the setup.
2. Place the platter through the turntable spindle,
then rotate the platter until you see the drive
motor pulley through the window at the top
left corner.
3. Carefully grab the drive belt and put it around
the slot of motor pulley.
4. Connect the power adapter to the turntable and power on the turntable.
5. Set the Motor Start/Stop switch to the Start position to see if the platter
motor spins. If the platter does not spin, try the steps listed above again.
7) Instruction Manual
8) Cartridge Alignment Protractor
9) USB-PC Cable
10) 2pcs lid spare rubber
11) Anti-skating Weight
12) Line out cable
7