Spraying Foliage With The Power Sprayer Wand - Crafstman 919.162252 Manual Del Propietário

SPRAYING FOLIAGE WITH THE POWER SPRAYER WAND

IRRITATING. READ THE SAFETY
LABEL OR INSTRUCTIONS FOR
EVERY CHEMICAL YOU SPRAY.
CAREFULLY FOLLOW ALL
INSTRUCTIONS REGARDING SKIN,
EYE AND RESPIRATORY
PROTECTION.
1. Prepare a mixture of chemical
and water in a 1-gallon bucket or
suitable container. Carefully
follow the directions on the
chemical container for the proper
water/chemical ratio.
NOTE: Thick or heavy chemicals
must be mixed with water to reduce
their thickness. Heavy materials will
not pass through the Power Sprayer
Wand.
2. Attach the chemical draw hose
and the air hose to the Power
Sprayer Wand. Place the free
end of the chemical draw hose
into the chemical/water mixture.
D20058
MANY CHEMICALS
ARE TOXIC OR
3. DO NOT attach a hose to the
garden hose connector for
foliage spraying. Be sure the
water control knob is in the "Off"
position.
4. For optimum performance set
your air compressor pressure
between 75 and 125 psig. Be
sure the air control knob is in the
"Off" position.
5. Extend the Foliage Nozzle out as
far as it will go.
6. Turn on the air compressor.
7. Begin the spraying procedure by
adjusting the air control knob
and the soap/chemical control
knob until you are spraying a
mist. You may vary the mist
pattern by pulling the foliage
nozzle in slightly.
8. To stop spraying, turn the air
control knob and the
soap/chemical control knob to
the "Off" position.
9- ENG
D20058