HQ AVSPLIT-45 Manual De Uso página 3

Step 4: Plug the 5 V DC power adapter into the AVSPLIT-45.Only use the supplied AC/
DC adapter.
Step 5: Turn on the power switch located on the rear panel.
Step 6: Turn on the lowest resolution display. Then turn on the other displays after the
lowest resolution display turns to normal operation (switched to HDMI input).
Step 7: When all connections are complete, the HD signal will be distributed to each
display.
Step 8: For the best performance, re-start the splitter after a HDMI cable has been
disconnected. This ensures the HDCMP will be working correctly.
ILLUSTRATION OF FULL INSTALLATION:
HDTV
HDTV
Display Display
ATTENTION:
• AVSPLIT-45 will distribute the image in a single resolution at a time. So make sure all
the displays you connect are compatible one resolution only at one time. Please set
the output resolution of the source device first, and make sure the resolution can be
displayed on all connected display devices.
• The resolution mode will depend on the first plug-in or the first device that successfully
communicates with the splitter. For optimal performance make sure your connected
devices are HDCP compliant and fully supports HDCP.
• To reset the splitter, turn off the power using the power switch on the back panel of the
device.
HDTV Source:BD
HDTV HDTV HDTV
Display Display Display
3
5 V DC Power Adapter
HDTV HDTV HDTV
Display Display Display