Publicidad
Idiomas disponibles
Idiomas disponibles
Wireless hand-held Microphone
1.
Mesh & capsule
2.
Power LED indicator
3.
Display
4.
Power switch
5.
Plastic body
6.
Battery cover
7.
Frequency identification cap
Operation of the microphone
• Open the battery cover (6) and insert a battery with the correct polarity. Close the battery
cover.
• Turn on the microphone power switch (4). The power LED indicator (2) will flash once and then go off. If the
indicator (2) keeps light up in red, the battery power is low. Please change the battery.
• When switching the microphone on, please proceed in 2 steps. Move the switch first to the center position
and wait for at least 0.2 seconds or it will produce noise. Then move to ON position.
Remote Control
1. CH-: Previous folder
2. CH+: Next folder
3. EQ: 00-NORMAL/01-POP/02-ROCK/03-JAZZ/04-CLASSIC/05-COUNTRY
4. : Previous file
5. : Next file
6. ▶ǁPlay/Pause
7. VOL-: Volume down
8. VOL+: Volume up
9. Number keys: Press the number of the file in the folder to select it directly. To
select a 2 digit file, press 0 or PICK SONG and then the 2 digits of the file. Eg.:
To select file 65, press 0/PICK SONG+6+5
10. Mode: Select between USB and Bluetooth mode
11. PICK SONG: To select directly a file number of 2 or more digits in USB mode
12. ENTER: Press once, FOLDER is displayed. The unit will play all files in the folder in sequence. Press
twice, ONE is displayed and the current song will be played continuously. Press 3x, ALL is displayed and
all songs in the folder will be played continuously. Press 4x, RANDOM is displayed and the songs in the
folder will be played in random sequence.
Quick Start
1. Set the POWER switch (2) to ON. The battery charge is indicated by the LED indicator (4). Please charge
the unit if the level is LOW. The unit will switch off automatically when the battery runs low.
2. Insert the power cord into the DC input jack (1) to charge the unit.
3. Turn on the microphone power switch. The RF LED (6) or (7) on the control panel will light. This means
that the receiver is receiving the signal and is in normal working condition.
4. To use an external sound source, insert a signal cable into the AUX/MP3 input (14). Adjust the volume via
the LINE / MP3 volume control (10).
IPS10-400 • 5
1
6
CH-
CH+
3
-
+
EQ
0
4
1
2
3
5
6
4
7
8
9
11
PICK SONG
ENTER
MODE
12
1
2
3
4
5
6
7
2
8
7
5
9
10
Publicidad
