Publicidad
Idiomas disponibles
Idiomas disponibles
1-1. Place the M10 Hollow Hex Bolt (SB-SC) into the large
hexagonal opening in Plastic Support Bracket (SB-MP)
as shown in Fig. 15.
1-2. Insert three small M4 Nuts (AN) into the cavities in Plastic
Support Bracket (SB-MP) as shown in Fig. 16.
1-3. Secure Square Adapter Plate (A5) to Plastic Support
Bracket (SB-MP) as shown in Fig. 17 using three M4
Small Screws (AA) and tighten with a screwdriver.
1-4. Place the M10 Hollow Hex Bolt (SB-SC) with the Square
Adapter (A5) through the long slot in the Horizontal
Support Plate (A1) or Extension (A4) and secure using
an M10 Washer (SB-S) and M10 Hex Nut (SB-SCN) as
shown in Fig. 18.
1-5. REPEAT Steps 1-1 through 4 for the 2nd set of Mounting
Brackets and Square Adapter Plates (A5).
1-6. Attach your soundbar with the manufacturer's mounting
brackets to the Square Adapter Plates (A5)
was included with your soundbar, or find the correct
Screws (A, G, or J), Washers (SB or SB-R), and Nuts
(AN, N, or JN) that work best with your soundbar.
See Fig. 19.
1-7. Make adjustments as necessary. Make sure your
soundbar is centered properly with the Horizontal Support
Plate (A1) and then
(SB-SCN) to lock the Support Brackets with Square
Adapter Plates (A5) into place.
. Use hardware that
the M10 Hex Nuts
8
Publicidad
