Descargar Imprimir esta página

Black and Decker BPWM20W Manual De Instrucciones página 19

Publicidad

Idiomas disponibles

Idiomas disponibles

SET UP & USE
A. Over the edge of a wash basin. Secure the guide
to the side of the basin wall with a hook or to the
tap with a piece of string to prevent the drain
hose from moving.
B. In a standpipe The standpipe must be no shorter
than 32 in. (81cm) and no longer than 39 in. (100cm).
C. In a laundry tub. The laundry tub must be no shorter
than 32 in. (81cm) and no higher than 39 in. (100cm).
Make sure that the connection between the
drain hose and the wash basin, standpipe or
laundry tub is not airtight.
Step 5: Leveling your washer
See if the washer is level by checking the position of the tub
or using a leveling gauge.
1. Slide the washer into position.
2. Open the lid of the washer, and pour the water into the tub
to just below the pulsator level.
3. If the washer is level, the pulsator is positioned at the center
of the washer as shown in the figure above right. If not, level
your washer by turning the front leveling leg clockwise or
counterclockwise as necessary.
There are TWO adjustable legs.
Step 6: Powering your washer
Plug the power cord into a 3-prong, well grounded 120 volt 60
Hz approved electrical outlet protected by a 15-amp fuse or
comparable circuit breaker. Your washer is grounded through the third prong of the
power cord when plugged into a 3-prong grounded electrical outlet.
Step 7: Running a test cycle
Run a test cycle as follows to check if your washer is properly installed.
1. Press the Power button to turn on your washer.
2. Press the PROCEDURE button repeatedly until the rise and spin cycles are
selected and the corresponding indicator lights are illuminated.
3. Press the Start/Pause button to start the test cycle.
4. washer should not rock or vibrate excessively when water is supplied or when
washing or spinning, and should drain well during the spin cycle.
5. The washer should run in the order of drainage, dehydration, water inflow and
rinsing.
If water leaks while water is being supplied or drained, check the water
connections. If the washer rocks and vibrates excessively, level your washer
again.
Step 8: Storing your washer
If you want to store your washer at another location, unplug it, drain any remaining
water from the drain pipe and hook the pipe onto the back of the washer.
Disconnect the water inlet hoses from the faucets and move washer to new
location.
Standpipe
Hose
retainer
39 in. Max
Tie
32 in. Min
strap
Laundry tub
Hose
retainer
39 in. Max
32 in. Min
Tie
strap
Pulsator
Leveling gauge
loosen
lock
Adjustable legs
Page 19
ENGLISH

Publicidad

loading