Installation And Assembly - Stanley ST-24P Manual De Instrucciones

Ventilador de alta velocidad
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

24" Pedestal Fan
24P
24POSC
Parts Included in Box:
(1) Base
(1) Front Guard
(1) Rear Guard
(1) Motor Assembly
(1) Fan Blade Assembly
(1) Locking Collar
(1) Upper Support Pole
(1) Lower Support Pole
(1) Support Pole Spring
Bag of hardware
Nut
Figure 1: Attaching Motor to Motor Support Assembly
Figure 2: Attaching Rear Guard to Motor
Motor Assembly
Pivot Bolt
Upper Support Pole
Rear Guard
Motor
OPERATION

Installation and Assembly

Tools Needed:
Pliers
Phillips head screwdriver
Flat head screwdriver
Adjustable wrench
1.
Remove the base from rear guard. Keep the (2) screws
holding the base to the rear guard. These screws will be
used to connect the base and lower support pole.
2.
Place the fan base on level ground.
3.
Loosen the locking collar on the support pole using the
provided Allen wrench (hex wrench). Extract the upper
support pole slowly to adjust the height of the fan. The
support pole must be fully extended before the spring
is placed inside. Place the spring into the bottom of the
upper support pole.
4.
Place the support pole plug into the bottom of the upper
support pole to secure spring in the upper support pole.
5.
Mount entire support pole to the base. Align holes and
use (3) screws from the hardware bag and the (2) screws
from Step 1 to secure the entire support pole to the base.
6.
Push down the base cover over the base support bolts.
7.
Mount the motor assembly to the connector on the upper
support pole (see Figure 1). Make sure the holes align.
8.
Secure motor assembly with Pivot Bolt and Nut. Tighten
the nut and bolt firmly using the wrench.
9.
Slide the rear guard onto the motor assembly and secure
it with (4) flange screws (screws from the motor). See
Figure 2. Tighten the screws firmly using the wrench.
10.
Loosen the screw on the back of the fan blade assembly
using the Allen wrench (Hex Wrench). Slide the fan blade
assembly onto the motor shaft.
11.
Tighten the screw on the back of the fan blade assembly
using the Allen wrench onto the flat part of the fan shaft.
12.
Attach the front guard to the rear guard and secure with
the fasteners on the front guard.
!
CAUTION: Do NOT slide fan blade screw beyond the
groove on the shaft! This will cause the fan blade to spin
improperly, damaging the fan! Be sure that fan shaft is
flush with front of fan blade assembly.
NOTICE: This model CAN NOT be wall mounted.
NOTICE: Fan is equipped with a thermal overload
shut-off for safety. The fan will turn off when exposed
to excessive heat. Allow the fan to cool down before
turning back on.
ENGLISH
3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

St-24posc

Tabla de contenido