Publicidad
Idiomas disponibles
Idiomas disponibles
Intended Usage
This power inverter is used for supplying electrical power for
operating compatible small electronics and USB-powered
devices such as cell phones, tablets, laptops, LED lights,
small fans, radios, etc. This device is not compatible for use
with appliances, power tools, air conditioners, sump pumps,
compressors, and/or other larger electrical devices.
Starting and Stopping
1. Slide the battery in the battery compartment. Push to
make sure it is locked in place (Fig. 4).
Fig. 4
2. Press the power button (status indicator LED) to turn the
inverter on. The button will light up green when ready to
use (Fig. 5).
Fig. 5
3. Plug the devices you want to power or charge into the
inverter's USB ports and/or 120 volt AC receptacle (Fig. 6).
Fig. 6
Battery pack
Power button (status
indicator LED)
9
4. When finished, disconnect your devices and press the
On/Off switch (status indicator LED) again to turn off the
power inverter. Remove the battery before storage.
Status Indicator LED
The power button is equipped with a LED light which serves as
a status indicator. Check below for different status indicated
by the LED.
• Solid Green Light – The inverter is in normal operating
condition.
• Blinking Green Light – The battery power is dropping.
Stop the inverter and charge the battery as soon as
possible.
• Solid Red Light – The battery is flat. Check the battery
charge level with the battery charge level indicator. Charge
the battery as needed. If the situation continues, there's
something wrong with the battery. Change the battery and
try again.
• Blinking Red Light – The inverter may be overloaded
or overheated. Turn off the inverter, disconnect all the
devices and wait for the inverter to cool down. Make
sure the battery pack is sufficiently charged to power the
devices, then press the power button to reset the inverter.
Reconnect the devices and try again. If the fault condition
immediately reoccurs, the current load exceeds the
capacity of the inverter.
If any other situation happened, Please call the Snow Joe
Sun Joe
customer service center at 1-866-SNOWJOE
®
(1-866-766-9563).
Using the LED light
1. Slide the battery in the battery compartment. Push to
make sure it is locked in place (Fig. 3).
2. Press the power button (status indicator LED) to turn the
inverter on. The button will light up green when ready to
use.
3. Press the light On/Off switch to turn on the LED light.
Press it again to turn off the LED light (Fig. 7).
Fig. 7
+
®
Light On/Off switch
Publicidad
