Troubleshooting - SKF TLGB 20 Instrucciones De Uso Y Mantenimiento

Troubleshooting

Condition
Grease gun fails to dispense grease.
Display flashing red due to motor overload.
Grease gun continues to lose prime.
Battery fails to take a charge.
Motor fails to run.
Cause
Grease tube assembly is out of grease.
Loss of prime.
Ball check (16) is not functioning.
Clogged whip hose.
Blocked lube point.
Clogged whip hose.
Air trapped in several locations in container
after bulk filling.
Follower binding in grease tube assembly.
Check ball seat (16) and check ball dirty.
No power to charger.
Battery may be bad.
Battery needs charging
Faulty wiring to motor.
17
Corrective action
Check that grease tube assembly has grease.
Repeat priming operation.
Remove ball check (16), clean and inspect ball
seat area.
Clean or replace whip hose. Remove blockages.
Clean or replace whip hose.
Clean or replace whip hose.
Empty grease tube assembly, refill and
repeat priming instructions.
Disassemble grease tube assembly and clean.
Be sure that follower has properly entered
grease cartridge.
Disassemble grease tube assembly and clean.
Be sure that follower has properly entered
grease cartridge.
Verify that the follower is not caught on rim of
grease cartridge.
Replace grease tube assembly (14) if damaged.
Clean check ball (16) and check ball seat.
Check that receptacle has power.
Replace battery.
Recharge battery.
Remove battery, disassemble handle and
check wiring connections on terminal,
trigger switch and motor.