Publicidad
Idiomas disponibles
Idiomas disponibles
8. Recommendations for a proper access to the model
Access
8 .1
Disconnect drain connection R1 and position it as to avoid hampering with fan shroud L1 .
8 .2
Remove deflector L6 and unfasten screws "A" of fan shroud L1.
8 .3
Bring fan shroud L1 to the position shown in drawing .
8 .4
Models with Ø315 mm fan motors only . To reach the heaters placed under the coil remove the inner drip trays L3 by
unfastening the self-threading screws "B" .
8 .5
It is possible to reach the header site by unfastening selfthreading screws "C" and removing the side panel L5 .
8 .6
Models with Ø350 mm fan motors are equipped with the safety system "D" that holds back the fan shroud L1 .
Reassembling
8 .7
Reposition the drip trays L3 and side panels L5 by fastening self threading screws "B" and "C" .
8 .8
Reposition the fan shroud L1 and fasten it with screws "A" .
8 .9
Reposition deflector L6 and reconnect drain connection R1.
L1
=
Fan shroud
L2
=
Sector
L3
=
Inner drip tray
L4
=
Supports
L5
=
Side panel
L6
=
Deflector
R1
=
Drain connection
SD
=
Junction boxes (fans and heaters)
=
Ground pole
Figure 4
29
www.modine.com
Publicidad
