Technical Specifications - cecotec BOLERO 10700 Manual De Instrucciones

ENGLISH
- Allow detergent solution to cool down.
- Unplug the machine from the power socket to avoid electrical shock before washing.
- The drain pump filter can filter the yarns and small foreign matters from the washing.
- Clean the filter periodically to ensure proper operation of the washing machine.
1. Open the lower cover cap. Fig. 33.
2. Rotate 90°C the emergency drain hose and pull it out, and take off the hose cap. Fig. 33.
3. When it is fully emptied, reset the drain hose. Fig. 34.
4. Open the filter by turning it counterclockwise. Fig. 35.
5. Remove dust, dirt and other substances or objects. Fig. 36.
6. Close the lower cover cap. Fig. 37.
Warning
Make sure that the valve cap and emergency drain hose are reinstalled properly, cap
plates should be inserted aligned to the hole plates.
*Some machines do not have an emergency drain hose, so step 2 and step 3 can be
skipped.
- Rotate the lower cover cap directly for water to run into the basin.
- When the appliance is in use and depending on the programme selected there
can be hot water in the pump. Do not remove the pump cover during a wash cycle,
always wait until the appliance has finished the cycle and is empty.
- When replacing the cover, ensure it is securely re-tightened.
6. TROUBLESHOOTING
Problem Cause
The washing machine The door is not closed
does not start up properly
The door does not open The safety lock system is
activated
Water leakage Bad connection between
pipes and water supply hose
or drainpipe.
Detergent residues in Detergent is dampened or
the box agglomerated
BOLERO DRESSCODE WASH&DRY 10700 INVERTER
84
Solution
Close the door and restart it
Check if there are clothes
stuck.
Unplug it and restart the
product.
Check and fasten water pipes
and hose.
Clean up outlet hose.
Clean and wipe the detergent
box
Indicator or display does The power PC board is
not light disconnected, or harness has
connection problem
Abnormal noise
Errors
Error Cause
E30 Door is not closed properly
E10 Water injecting problem while
washing
E21 Overtime water draining
E12 Water overflow
EXX Others

7. TECHNICAL SPECIFICATIONS

Product: Bolero DressCode Wash&Dry 10700 Inverter
Reference: 02339
Washing capacity: 10 kg
Drying capacity: 7 kg
Dimension (W*D*H) cm: 59.5*56.5*85
Net weight: 72 kg
Rated power: 1900 W
Drying power 1300 W
220-240 V~,50 Hz, 10 A
Standard water pressure: 0.05 MPa~1 MPa
IPX4
Made in China | Designed in Spain
BOLERO DRESSCODE WASH&DRY 10700 INVERTER
ENGLISH
Check if the power is shut
down and the power plug is
connected correctly.
Check if the fixing bolts have
been removed.
Make sure the appliance is
installed on a solid, level
floor.
Solution
Close the door and restart it.
Check if there are clothes
stuck.
Check if the water pressure is
too low.
Straighten the water pipe.
Check if the inlet valve filter is
blocked.
Check if the drainpipe is
blocked.
Restart the appliance.
Contact the official Technical
Support Service of Cecotec.
85