Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
90519175 SPT100 Multi tool
F
SAVE THESE INSTRUCTIONS
BATTERY INSTALLATION
The SPT100 tool uses a 9 volt battery. Remove the battery compartment cover (13) by
pressing on the center of the cover as shown in figure B and sliding out. Insert a fresh 9
volt battery making sure to match (+) and (-) terminals correctly. Replace the battery
compartment cover.
WARNING: Batteries can explode, or leak, and can cause injury or fire. To reduce
this risk:
• Carefully follow all instructions and warnings on the battery label and package.
• Always insert battery correctly with regard to polarity (+ and -), marked on the battery and
the equipment.
• Do not short battery terminals.
• Do not charge battery.
• Remove dead battery immediately and dispose of per local codes.
• Do not dispose of battery in fire.
• Keep batteries out of reach of children.
• Remove battery if the device will not be used for several months.
"Transporting batteries can possibly cause fires if the battery terminals inadvertently
come in contact with conductive materials such as keys, coins, hand tools and the like.
The US Department of Transportation Hazardous Material Regulations (HMR) actually
prohibit transporting batteries in commerce or on airplanes (i.e. packed in suitcases
and carryon luggage) UNLESS they are properly protected from short circuits. So
when transporting individual batteries, make sure that the battery terminals are
protected and well insulated from materials that could contact them and cause a short
circuit."
OPERATING INSTRUCTIONS
SCREWDRIVER
Bit Insertion
To install a bit simply insert it into the cavity in the spindle (5) until it snaps into place. To
remove the bit pull it straight out. If bit does not fit into spindle, rotate the bit and re-insert it.
Switch
Forward
• Press the front of the forward/reverse switch (1) shown in figure C and the tool will run in
a forward direction. Release the switch and the tool will stop.
Reverse
• Press the back of the forward/reverse switch (1) and the tool will run in a reverse
direction. Release the switch and the tool will stop.
Spindle Lock
The screwdriver has a high-speed, low-torque transmission specifically designed
for long machine screws. Because of this specialized design, it will not strip threads
when used on the small screws typical of electrical boxes.
The transmission has an automatic spindle lock, which allows you to manually apply high
torque to a screw when necessary. To use the spindle lock, leave the screwdriver in the
6/7/07
10:10 AM
Page 6
G
6
Publicidad
