Installation guide
4.5 Assembling the ilmo2 WT module with the
tube fitted with the S tubular module
Fit the tube complete with S tubular module (D)
1)
to the end bracket (J).
Insert the connector (K) of the ilmo2 WT
2)
module (E) into the S tubular module (D).Screw
the connector (K) into the S tubular module (D).
Fit the tube complete with S tubular module (D)
3)
to the motor bracket (L).
Fit the stop ring (M).
5. Wiring
Turn off the power supply.
1)
Connect the motor according to the information
2)
in the table below:
230 V 50 Hz
a
Blue
b
Brown
c
Black
d
Yellow/green
6. Commissioning
Switch the power back on.
1)
Press the "Up" button at the control point:
-
If the roller shutter rises, the wiring is
►
correct and commissioning is finished.
If the roller shutter is lowered, go to the
►
next stage.
Switch off the power.
2)
Reverse the brown wire and the black wire
-
connected to the control point.
Switch the power back on.
3)
Press the "Up" button to check the direction of
-
rotation.
Copyright © 2008 - 2017 Somfy Activités Société Anonyme. All rights reserved.
Cable
Neutral (N)
Live, Direction 1
Live, direction 2
Earth ( )
ilmo 50 S WT
1
D
2
E
D
K
3
M
L
1
OFF
2
b
a
N
c
d
l
1
ON
2
OFF
3
ON
J
D
a
b
c
d
43