Mesko MS 5037 Manual De Uso página 4

19. Be careful that the power cord does not touch the hot soleplate. Allow the iron to cool
completely before storage.
20. If you do not use iron, even for a short time, turn off the options of steam
21. Under no circumstances should be ironed clothes and fabrics that are on humans or
animals.
22. Never direct the steam to humans or pets.
23. Iron must be used at a stable even surface and this can only be disposed of.
24. Do not fill the water tank with chemicals, perfumes or descaling substance.
DESCRIPTION OF DEVICE
A. Spray nozzle
C. Steam Control Lever
E. "Steam burst" button
G. Thermostat knob - temperature control
I. Ceramic soleplate
IRONING
First use
When using the iron for the first time, you may notice a slight emission of smoke and hear some sounds made by the expanding
plastics. This is quite normal and it stops after a short time. We also recommend passing the iron over ordinary cloth when using it for
the first time.
Preparation
Sort the laundry to be ironed according to the international symbols on the garment label, or if this is missing, according to the type of
fabric.
GARMENT
Start ironing the garments requiring a low temperature.
This reduces the waiting times (the iron takes less time to heat up than to cool down) and eliminates the risk of scorching the fabric.
STEAM IRONING
1. Check that the plug is disconnected from the socket.
2. Move the steam selector (C) to "0".
3. Open the lid (B). Raise the tip of the iron to help the water enter the opening without overflowing.
4. Slowly pour the water into the reservoir using the special measure and take care not to go over the maximum level (about 170ml)
indicated by "MAX" on the reservoir. Close the lid (B).
5. Place the iron in a vertical position. Plug it into the electricity.
6. Set the thermostat knob (6) in accordance with the international symbol on the clothes labels.
7. Thermostat control light indicates (H) that the iron heats up. Wait until the indicator lights off. You can then start ironing.
8. The amount of steam is adjusted with the lever of the steam regulator (C). Set the steam regulator, depending on the desired amount
of steam.
Warning: When you ironing, the thermostat control light (H) turns on from time to time, this means that the selected temperature is
maintained at a constant level. If you decrease the temperature, do not begin ironing again until the thermostat light does not light up.
Warning: The iron gives off steam continuously only if you hold the iron horizontally. You can stop the continuous steam by placing the
iron in a vertical position or by moving the steam selector to "0".You can only use steam at the highest temperatures. If the selected
temperature is too low, water may drip onto the cloths.
Selecting the steam burst button (E) and steam when ironing vertically.
Press the steam burst button (E) to cause rapid ejection of a strong jet of steam, which easily penetrates the fabric and can smooth out
most wrinkles. Wait a few seconds before re-using this button.
Using a steam burtst button (at the correct time between use) can also be ironed iron in a vertical position (curtains, hanging clothes,
B. The water inlet hole
D. Spray button
F. Power Cord
H. Thermostat indicator light
J. Water tank
LABEL
FABRIC
TYPE
synthetic
silk - wool
Cotton - linen
Fabric not to be ironed
4
THERMOSTAT
REGULATION
·
low temperature
··
medium temperature
···
high temperature