Connectivity Functions; Practical Advice - Bosch GBH 18V-36 C Professional Manual Original

Power tool status Meaning/cause
indicator (20)
Flashing blue Power tool is establishing a connection to a
mobile device or settings are being trans-
ferred
Smartphone symbol (21) Meaning/cause
− Further information can be found under the "Power tool status" display on a mobile device if it
is connected via Bluetooth® wireless technology.
Selecting the working mode
Working mode (18) indic- Functions
ator
Auto working mode: Fast, controlled run-up up to maximum power
lights up
– "Hammer drilling" operating mode (Electronic Precision Control soft start): Fast, con-
– Rapid Shut-off (KickBack Control) active
– "Chiselling" operating mode (Adaptive Speed Control soft start): Fast, controlled run-up up
Soft working mode: Reduced power for processing sensitive materials
lights up
– "Hammer drilling" operating mode (Electronic Precision Control soft start): Slow, strictly
– Rapid shut-off (KickBack Control) with an even more sensitive setup
– "Chiselling" operating mode (Adaptive Speed Control soft start): Slow, strictly controlled
Favourite working mode: Individual configuration via smartphone app
lights up
The following settings are pre-programmed:
– "Hammer drilling" operating mode (Electronic Precision Control soft start): Fastest pos-
– Rapid Shut-off (KickBack Control) active
– "Chiselling" operating mode (Adaptive Speed Control soft start): Deactivated, fastest pos-

Connectivity functions

In conjunction with the Bluetooth® Low Energy Module
GCY 42, the following connectivity functions are available
for the power tool:
– Registration and personalisation
– Status check, output of warning messages
– General information and settings
– Management
Read the corresponding operating instructions for informa-
tion about the Bluetooth® Low Energy Module GCY 42.

Practical Advice

With the Bluetooth® Low Energy Module GCY 42, the
u
power tool is equipped with a radio interface. Local
operating restrictions, e.g. in aircraft or hospitals,
must be observed.
In areas where the Bluetooth® wireless technology is
u
not allowed to be used, the Bluetooth® Low Energy
Module GCY 42 and the button cell must be removed.
Bosch Power Tools
trolled run-up up to maximum power
to maximum power
controlled run-up up to reduced, low power
run-up up to reduced power
sible run-up up to maximum power
sible run-up up to maximum power
Note: The cover (11) can only be securely closed if the
Bluetooth® Low Energy Module GCY 42 and the button cell
are situated in the power tool.
– To deactivate the Bluetooth® Low Energy Module
– Close the cover (11) to prevent dirt from getting in.
Overload clutch
u
u
Solution
–
GCY 42, rotate the button cell or place means of insula-
tion between the button cell and Bluetooth® Low Energy
Module GCY 42.
If the application tool jams or snags, the power trans-
mission to the drill spindle will be interrupted. Always
hold the power tool firmly with both hands to with-
stand the forces this may create and adopt a position
with stable footing.
Switch the power tool off immediately and remove the
application tool if the power tool becomes blocked.
Switching on when the drilling tool is blocked may
cause high torque reactions.
1 609 92A 7SK | (24.06.2022)
English | 21