Publicidad
Idiomas disponibles
Idiomas disponibles
Base assembly
•
Remove the tilt adjustment knob (9) by
unscrewing the knob and slide the tilt adjustment
bolt (3) out. Then remove the base thumb screw
(11) and the base washer (6) by unscrewing as
shown.
•
Take the base (5), base thumb screw (11), base
washer and post (6). Fit the post into the recess in
the top of the base and whilst holding it in place,
turn over to access the underneath. Place the
washer over the hole and then insert the base
thumb screw (11). Tighten securely, then turn the
assembly the rightway up and sit on a fl at bench
top.
Head assembly
•
Using a screwdriver, remove the small tilt range
screw (10) from the coupling bracket on the fan
neck and then unscrew the small tilt range knob
(2).
IMPORTANTE: make sure the post and fan head are in the correct
orientation when assembled.
23
|
Publicidad
