Publicidad
Idiomas disponibles
Idiomas disponibles
30 • ENGLISH
BATTERY
Voltage
Capacity
Ah
Battery type
* Maximum initial battery pack voltage (Measured without
a workload) is 20 volts. Measured under a workload,
nominal voltage is 18V.
PROBLEM
Unit will not start.
Battery packwill not charge.
Unit shuts off abruptly.
SERVICE INFORMATION
BLACK+DECKER offers a full network of company-owned and authorized service locations. All BLACK+DECKER
Service Centers are staffed with trained personnel to provide customers with efficient and reliable power tool service.
For more information about our authorized service centers and if you need technical advice, repair, or genuine factory
replacement parts, contact the BLACK+DECKER location nearest you, or visit us at www.BlackandDecker-la.com
LD120BAT
20 V
MAX*
1.5
Ion-Lithium
TROUBLESHOOTING
POSSIBLE CAUSE
Battery pack not installed properly
Battery pack not charged.
Attachment is not secured.
Battery pack not inserted into charger.
Charger not plugged in.
Surrounding air temperature too hot
or too cold.
Battery pack has reached its
maximumthermal limit.
Out of charge. (To maximize the life
of the battery pack it is designed to
shut off abruptly when the charge is
depleted.)
DRILL/DRIVE
ATTACHMENT
.../min
Speed
(cpm)
Chuck
in (mm)
Torque
ft-lb (Nm)
Variable
speed
POSSIBLE SOLUTION
Check battery pack installation.
Check battery pack charging requirements.
Make certain the attachment is fully pushed
into the Power Unit.
Insert battery pack into charger until green
LED appears
Plug charger into aworking outlet. Refer to
"Important Charging Notes" formore details.
Move charger and battery pack to
a surrounding air temperature of above 40°F
4,5°C) or below 105°F (+40,5°C).
Allow battery pack to cool down.
Place on charger and allow to charge.
BDCMTDD
0 - 800
3/8 (10)
0.00
(20.9)
Yes
Publicidad
