Publicidad
Idiomas disponibles
Idiomas disponibles
SELECTING THE AIR FLOW
In air conditioning and fan modes, press
select the desired air flow.
The air flows available are:
Minimum air flow: when most silent operation is
desired.
Maximum air flow: for maximum performance.
Auto air flow: the appliance automatically chooses
the air flow based on the temperature selected and
the environmental conditions.
This function is available in the air conditioning mode
and is permanently set in the dehumidifying mode.
SELECT THE TEMPERATURE SCALE
The temperature can be displayed in °C or °F. To change the tem-
perature unit of measure select the air conditioning mode then
press both the decrease
about 3 sec. The change of the unit of measurement is confirmed
by an acoustic signal.
SETTING THE TIMER
The timer allows the delayed start up or shut down of the appli-
ance. This function will prevent wasting electricity by optimising
the operating periods.
SELF-DIAGNOSIS
The appliance has a self diagnosis system to identify a number of warning/malfunctions.
Error messages are displayed on the appliance display.
IF ... IS DISPLAYED,
"Low Temperature"
(Frost prevention)
..WHAT SHOULD I DO?
The appliance is fitted with a frost protec-
tion device to avoid excessive formation of
ice. The appliance starts up again auto-
matically when the defrosting process is
completed.
button (D3) to
(D5) and increase
(D4) keys for
..WHAT SHOULD I DO?
If this is displayed, contact your local au-
thorized service center.
How to program delayed shut down
•
While the appliance is on in any operating mode, delayed
C11
shut down can be programmed.
C15
•
Press the
C8
ed and the hours light up.
C10
•
Press the
numbers of hours to shut down appears on the display.
C14
A few seconds after the timer is set, the setting is acquired, the
display shows the operating mode and the timer symbol stays lit.
Once the set time is elapsed, the air conditioner goes into standby.
To cancel the timer program, press the
twice. The timer symbol will go off.
How to program delayed start up
C3
C11
•
Plug in the appliance and set to standby.
C15
•
Press the
C2
C8
palyed and the hours light up.
C10
•
Press the
numbers of hours to start up appears. Start up can be pro-
grammed at any time within the 24 hours that follow.
C14
When the set time is elapsed, the appliance will start to operate
in the same operating mode that was previously set.
To cancel the timer program, press the
twice. The timer symbol will go off.
C3
C2
IF ... IS DISPLAYED,
"Probe Failure"
(Probe damaged)
16
C5
C6
C7
timer button (D6), the timer symbol is dispaly-
C9
(D5) and
(D4) buttons until the desired
C12
C13
C11
C15
C8
C10
C5
C4
C6
C7
C14
timer button (D6), the timer symbol is dis-
C1
C9
(D5) and
(D4) buttons until the desired
C12
C3
C13
C11
C15
C2
C8
C10
C4
C14
C1
C3
C2
IF ... IS DISPLAYED,
"High Level"
(Internal tray full)
..WHAT SHOULD I DO?
Empty the internal safety tank following
the instructions in the section "End of
season operations".
C5
C6
C7
timer button (D6)
C9
C12
C13
C5
C4
C6
C7
timer button (D6)
C1
C9
C12
C13
C4
C1
Publicidad
