Initial Startup - Kärcher K 4 Power Control Manual De Instrucciones

Mounting the accessory net
1. Hook the accessory net into the
hooks.
Inserting the high-pressure hose
through the hose guide
1. Insert the high-pressure hose
through the hose guide from behind.
Mounting the coupling for the
water connection
1. Screw the coupling for the water
connection onto the water connec-
tion of the device.
10

Initial startup

1. Place the device on a level surface.
2. Unwind the high-pressure hose
completely and release any loops or
twists.
3. Pull the high-pressure hose com-
pletely forward through the hose
guide.
4. Insert the high-pressure hose into
the high-pressure gun until it audibly
clicks into place.
Note
Make sure the nipple is oriented cor-
rectly.
5. Check the secure connection by
pulling on the high-pressure hose.
6. Insert the mains plug into an outlet.
Water supply
For connected loads, see type plate or
chapter Technical data.
Observe the instructions of the water
supply company.
Connection to the water line
ATTENTION
Hose coupling with aquastop on the
water connection of the device
Damage to the pump
Never use a hose coupling with aquas-
top on the water connection of the de-
vice.
You can use an aquastop coupling on
the tap.
English