Descargar Imprimir esta página

Overheat Protection - HOMCOM 820-245 Manual De Montaje E Instrucciones

Publicidad

Idiomas disponibles

Idiomas disponibles

(d) + , - : adjust room temperature .Temperature setting from 10-49 . Press " + " to
increase the desired temperature and " - " to decrease the desired temperature.
When the room temperature lower 4
working, lower 2 , lower power working, if room temperature reach the setting
temperature, the heating stop, fan is permanently on till room temperature lower
than the setting temperature 2 , the unit automatically return to lower power
heating, if room temperature lower 4
return to heating.
(e) Swing : Press
(f) Press
to turn off the heater, the unit will keep working 30 seconds of cool air
after turn off it . this design can protect item use longer.
Warning:
1. Before removing the plug from the socket, switching off and better work for 30-
60 second for cool down in condition that protecting inner parts.

OVERHEAT PROTECTION

This heater is protected with an overheat protection that switches off the heating
automatically in case of overheat,e.g. due to the total or partial obstruction of the
grids. In this case, waiting to the appliance cool and removing the object which is
obstructing the grids. Then the thermal cut-out will automatically reset, heating as
normally.
Should the problem persist, please contact the nearest customer service.
NOTE: To assist in maintaining the internal components, after pressing the OFF
button the fan
will continue to blow room air for a period of 30-60 seconds before shutting down to
standby.
Remote Control
The remote control requires 1 CR2025 3V lithium battery (included)
Important: Follow the instructions of use and the recycle rules given on the battery
packaging.
1- Open the battery compartment by sliding the cover down.
2- Insert the battery into the compartment,
observing the polarity in the diagram (see below drawing).
3- Close the battery compartment.
NOTE: the remote control buttons perform the same functions as those on the
control panel on the unit.
than= í Ü É = ë É í í l ed temperature of unit, it's high power
, higher power heating, it's automatically
to activate swing. Press it again to cancel.
4
EN

Publicidad

loading