The torch must be fitted with the correct consumables, chosen according to the application and the set current.
Choosing the incorrect consumable will result in cutting defects, premature wearing of the consumables and could even cause the entire unit to
malfunction. The torch is supplied with a pot of silicone grease to minimise the seal's wear and the seizing of metal parts. It is recommended to apply
this grease regularly.
Consumables
Regularly check the condition of the protective nozzle, the contact tip and the electrode for wear and tear, also check these parts if the cutting speed
is significantly reduced. It is advisable to replace the nozzle's contact tip and the electrode at the same time.
MT & EASYFIT
Torch model
Calibrate
20 - 50 A
MT-70
Precision cut
Cutting
MT-125
Calibrate
MT-70
65 - 85 A
Gouging
MT-125
MT / EASYFIT / AT
A
B
B
A
C
Diffuser (x1)
Electrode (x5)
037564
067189
037557
037564
70 A
067189
039131
45 A
45 A
039131
65 A
85 A
105 A
039148
125 A
Diffuser (x1)
Electrode (x5)
70 A
037557
039131
105 A
039148
125 A
To assemble the handle bundle with an EASYFIT torch, insert
the torch connector (A) into the bundle socket and screw on
part B. Tighten the torch.
Connecting the torch to the power source:
Insert the handle bundle connector (A) into the power source's
female bundle socket (C) and screw on part B. Tighten the torch.