H-3448
AUTOMATIC PAPER
TOWEL DISPENSER
MOUNTING
Mount dispenser securely on wall with supplied
hardware. Bottom edge should be approximately 52
inches above the floor.
OPENING THE COVER
Key is taped to back of dispenser.
1.
Insert forked end of key into two slots at top of cover.
2. Push down on key and pull forward on cover.
NOTE: Opening the cover removes battery
power from control circuit.
LOADING BATTERIES
1. Open cover. Squeeze tabs on battery housing
inward then rotate housing forward and down.
(See Figure 1)
Tabs on Battery Housing
Figure 1
2. Insert four "D"-size alkaline batteries with "LR20"
designation.
(Battery orientation is embossed on compartment.)
NOTE: We do not recommend using
rechargeable "D"-size batteries.
PAGE 1 OF 12
1-800-295-5510
uline.com
OPERATION
3. Red LED will flash while system initializes.
4. When battery power is low, Low Battery Indicator
LOADING PAPER ROLL
Loading the dispenser without a stub roll.
1. Open cover and load paper roll with paper "tail"
2. Press the sheet feed button. Firmly close dispenser.
Pour le français, consulter les pages 9-12.
Light will turn on. (See Figure 2)
unwinding from back of roll. Place paper "tail" under
transfer bar arm.
Unit initially dispenses at factory-set control settings.
(See Figure 3)
Transfer Bar
Para Español, vea páginas 5-8.
Figure 2
Low Battery
Indicator
Light
Figure 3
Sheet Feed
Button
0721 IH-3448