Publicidad
Idiomas disponibles
Idiomas disponibles
2
FINAL WATER CONNECTION
Brass
Nut
3/8"
Plastic
Tube
Property Damage: Join remaining tube
to cold water supply only.
3
TURN ON WATER & CONNECT POWER
Scalding Hazard: The faucet dispenses near-boiling
(212ºF) water which can instantly cause scalds or
burns. Use care when operating this appliance.
F-201R Cartridge (included with this system) Chemical & Mechanical Reduction Filter Specifications:
This cartridge provides mechanical and chemical reduction of dirt/rust, taste/odor, chlorine and particulates.
Tested and Certified by NSF International against
NSF/ANSI Standard 42 in model F-201 for the reduction
of claims specified on the Performance Data Sheet.
Filter Capacity: 500 gallons, depending on local water conditions. Note that while the testing was performed under
standard laboratory conditions, actual performance may vary. Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before or after the system. For cold water use only. Systems must be
installed and operated in accordance with the Manufacturer's recommended procedures and guidelines. See warranty
card for warranty. For service and parts, contact your local dealer or InSinkErator
Application guidelines/Water Supply Parameters for NSF Testing: Service flow of 0.75 gpm, community or
private well water supply, water pressure of 20-120 psi, water temperature of 33˚F–100˚F. Except as noted, all
testing performed at pH = 7.5 ± 0.5, Flow: 0.75 gpm, Pressure: 60 psi, Temp: 20˚± 3˚C.
Contact an authorized InSinkErator service agent for repairs or replacement components.
Ferrule
Brass
Insert
I I
Install a T-fitting (not included)
onto the cold water supply line.
I I
Install dedicated water control valve
with 3/8" compression fitting.
I I
At the end of the white 3/8" tube
from the filter or quick-connector,
slide the supplied brass nut and
ferrule over the tube and then push
in the brass tube insert.
I I
Insert the white 3/8" tube into the 3/8"
compression fitting and tighten.
I I
Turn on the water supply.
I I
Depress the dispenser's HOT handle
and hold it until water flows from the
spout (approximately 1 to 2 minutes).
I I
For the F-201 and F-201R, flush 2.25
gallons through filter before use
(approximately 3 minutes). For the
F-601R, flush 3 gallons through filter
before use (approximately 3 minutes).
Pressure: 20-120 psi
Temperature: 33
º
F - 100
º
F
Flow Rate: 0.75 gpm
Capacity: 500 gallons
®
directly at 1-800-558-5700.
5
Publicidad
