Noise Information; Vibration Information - Worx WX891 Manual Original

Machine weight (bare tool)
** X=1-999, A-Z, M1-M9 there are only used for different
customers, there are no safe relevant changes between
these models.
*** Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal voltage
is 18 volts.
Category
20V Battery
20V Charger
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to the
accessory packaging for further details. Store personnel
can assist you and offer advice.

NOISE INFORMATION

A weighted sound pressure
A weighted sound power
K & K
pA wA
Wear ear protection.

VIBRATION INFORMATION

Vibration emission value: a
Uncertainty K = 1.5 m/s²
The declared vibration total value and the declared noise
emission value have been measured in accordance with
a standard test method and may be used for comparing
one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a preliminary
assessment of exposure.
WARNING: The vibration and noise emissions
during actual use of the power tool can differ from
the declared value depending on the ways in which
20V Cordless Drain Auger
3.4 kg
Type Capacity
WA3550 1.5 Ah
WA3550.1 1.5 Ah
WA3551 2.0 Ah
WA3551.1 2.0 Ah
WA3553 4.0 Ah
WA3014 4.0 Ah
WA3760 0.4 A
WA3869 2.0 A
WA3880 2.0 A
L : 82 dB(A)
pA
L : 93 dB(A)
wA
3 dB(A)
= 2.13 m/s
2
h
the tool is used especially what kind of workpiece is
processed dependant on the following examples and
other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome
if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off and
when it is running idle but not actually doing the job. This
may significantly reduce the exposure level over the total
working period.
Helping to minimise your vibration and noise exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE:
It is a handheld drain auger, used to dredge the 19-76mm
of the pipes.
Assembly and Operation
Action
BEFORE OPERATION
Removing the battery pack
Charging the battery back
Installing the battery pack
OPERATION
Flexible shaft advances to the
blockage
-- Adjust the switch correctly
9
Figure
See Fig. A1
See Fig. A2
See Fig. A3
See Fig. B
EN