PowerFit PF31001B Guia De Inicio Rapido

tRIGGeR hANdle
pF31001b
WARNING:
To reduce the risk of injury, user must read and under-
stand the operator's manual for their pressure washer
before using this accessory. Always wear eye protec-
tion. Risk of fluid injections; do not point at people, pets,
electrical devices, or the unit itself. Turn off the pressure
washer before changing or adjusting accessories. For
cold water use only.
INstAllING the tRIGGeR hANdle
See Figure 1.
n Screw the collar of the high pressure hose onto the trigger
handle's inlet coupler by turning the hose collar clockwise.
n Pull on the hose to be certain it is properly secured.
AssemblING the spRAy WANd
See Figure 2.
n Place the threaded end of the spray wand in the connec-
tor on the end of the trigger handle.
NOte: Be careful to avoid cross-threading, which can
cause the trigger handle to leak during use.
n Turn the connector clockwise until it stops. This secures
the spray wand in place.
usING the tRIGGeR hANdle
See Figure 3.
For greater control and safety, keep both hands on the trig-
ger handle at all times.
n Pull back and hold the trigger to operate the pressure
washer.
n Release the trigger to stop the flow of water through the
nozzle.
to engage the lock out:
n Push up on the lock out until it clicks into the slot.
to disengage the lock out:
n Push the lock out down and into its original position.
To use the spray wand, start with the nozzle 1-2 ft. away
from the cleaning surface. Carefully approach the surface
just until the desired level of cleaning is achieved. If the spray
is too close it can damage the cleaning surface.
WARNING:
To reduce the risk of injury from kickback, hold the trigger
handle securely with both hands when the machine is on.
speCIFICAtIONs
Maximum Pressure
Maximum Gallons Per Minute Flow
Maximum Inlet Water Temperature
collAr
trigger
hAnDle
connector
trigger
3100 psi
5 gpm
104°F
inlet
coupler
high preSSure
hoSe
Fig. 1
SprAY
WAnD
Fig. 2
Slot
lock out
Fig. 3