FONESTAR FO-22CAT8 Manual De Instrucciones página 5

EN
REMOTE CONTROL
SERIAL COMMUNICATION PROTOCOL
To control the equipment via serial communication, use a USB-microUSB cable to connect the transmitter
equipment to your PC. It is recommended to use Hyperterminal, I/O Ninja or similar applications and configure
it as follows::
Select the corresponding COM port and set the following values:
- Bits per second: 115200
- Data bits: 8
- Parity: None
- Stop bits: 1
This is the list of commands and their function. Note that the symbols "[" and "]" are used below to make the
command easier to understand. They should not be used when typing the command.
- 5 -