Dahlert DT-SJ-19 Manual De Instrucciones página 17

17
USING POWER DIAL / WHEN SCREW STOPS IN USE
Using Power Dial
① Turn to up (clockwise) to 'Extract', set in the middle to 'Stop', and turn to down (counterclockwise) to 'Reverse'.
② For safety, the machine will not stop instantly but slow down to a stop when you set the dial to Stop [ ].
③ Reverse [REV] feature is active when you are holding the dial on [REV]. (Stops when you remove your hand.)
Screw Stops in Use
 The screw may stop if you put ingredients too much or too quickly.
 If the machine does not resume even after the following remedies, turn off the machine and contact
Dahlert Customer Center.
1
Turn the power dial to the direction of [REV] and hold it for 3~5 seconds (counterclock-
wise) and let it go. Repeat this 2-3 times.
The "Reverse" feature pushes the ingredients in the chamber upwards. The "Reverse" feature is active
when you are holding the dial and stops when you remove your hand.
2
When the reverse motion comes to a complete stop, turn the power dial to the direction
of [ON] (clockwise) to run.
When turning power dial to the direction of [ON] or [REV], make sure the screw comes to a complete stop
first before turning the dial to the direction of your choice.
4DC01742 사용설명서 DT-SJ-19(102-A2) 7개국어_V.00.indd 17 2019-08-13 오후 6:28:08