Back-Up Battery - Bellman & Symfon BE1260 Manual De Instrucciones

14
Bellman Visit Charger
This is what to do!
1. Place the charger on a table or hang it on the wall. If it is placed vertically on a table the sup-
port legs should be fitted on the back of the charger.
2. Insert the mains adapter in a power point and connect one or two bed-shakers as required.
3. Insert Bellman Visit Pager in the charger. When the charging is completed (see section
"Charging lamp") you can begin to use the pager.
Charging lamp
The charging lamp is green and placed on the front of the charger. It lights up when you insert the
pager in the charger. This indicates that it is correctly connected and charging is in progress. When
the battery is charged the charging lamp goes off. The charging lamp is off when the pager is not in
the charger.

Back-up battery

The back-up battery is built into the charger and charges automatically when the charger's mains
adapter is connected to a power point. In the event of a powercut the back-up battery supplies the
bed-shakers with power so there is no need to worry about missing the alarm.
Bed-shaker
One or two bed-shakers can be connected to the charger in the vibrator outputs A and B. When the
pager is in the charger it will not vibrate, the bed-shakers will vibrate instead according to the same
pattern as the pager. The LEDs on the pager light up as usual.
Trouble shooting
A fault is not always serious. Follow the trouble shooting schedule below before calling for service.
Symptom
The pager does not charge when it is in Check that the pager is placed correctly in the charger. When the
the charger. pager is inserted in the charger the charging lamp lights up.
The bed-shakers do not vibrate when Check that the bed-shakers are correctly connected to the
the alarm is set. charger and that the pager is correctly inserted in the charger.
Production description
1) Output A
2) Charging pin
3) Charging lamp
Procedure
4) Output B
5) Support leg
15
CZ
DE
DK
ES
FI/
FR
GB
HU
IT
NL
NO
PL
PT
SE
YU