Installing And Removing The Battery Pack - DeWalt DCBL772 Manual De Instrucciones

Soplador de mano con batería de iones de litio de 60 v máx
Ocultar thumbs Ver también para DCBL772:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
Blow Tube Assembly (Fig. D)
1. To attach the tube to the blower, line up the pegs
the bottom of the tube with the notch
of the housing opening as shown in fig. D.
2. Push the tube into the blower housing until the lock
engages the tube.
3. Pull on the tube to ensure it is securely in place.
4. To remove the tube, insert a screwdriver into the
unlocking hole
 9 
on the side of the blower tube.
Depress the tab inside and pull tube off.
Fig. D
9
OPERATION

WARNING:
without tube securely in place. Never reach down into
housing through tube hole.

WARNING:
when you leave blower unattended or when storing,
checking, adjusting, cleaning, or working on blower.

Installing and Removing the Battery Pack

(Fig. E, F)
nOTE: For best results, make sure your battery pack is
fully charged.

WARNING:
battery, make certain the speed lock lever
off position to prevent switch actuation.
To install battery pack: Insert battery pack
housing
 6 
as shown in fig. E until fully seated and an
audible click is heard. Make sure battery pack is fully seated
and fully latched into position.
To remove battery pack: Depress the battery release
button
 11 
in the top of the battery housing and pull
battery pack out of appliance.
fig. E
8
 8 
on the bottom
8
7
Do not operate blower
Always remove the battery
Before removing or installing
 2 
is in the
 10 
into battery
6
Proper Hand Position (Fig. A, E)

 7 
on
WARNING:
personal injury, ALWAYS use proper hand position
as shown.

WARNING:
personal injury, ALWAYS hold securely in anticipation
of a sudden reaction.
Hold the blower with one hand on the main handle
Fig. E
OPERATION

WARNING:
without blow tube securely in place. Never reach down
into housing through tube hole.

WARNING:
glasses. Wear a filter mask if the operation is dusty.
Use of rubber gloves and substantial footwear is
recommended when working outdoors. Keep long hair
and loose clothing away from openings and moving
parts.

WARNING:
the tool off, wait 10 seconds for the fan to stop
rotating before removing the blower tube.
Always ensure the blower is switched OFF and the
battery is removed when:
-
You leave blower unattended.
-
Clearing a blockage.
-
Checking, adjusting, cleaning or working on blower.
10
Only use blower in daylight or good artificial light.
11
To reduce the risk of serious
To reduce the risk of serious
4
4
Do not operate blower
Always wear safety
Cut Hazard. When turning

Publicidad

Tabla de contenido
loading

Tabla de contenido