HID Signo 25B Guia De Instalacion página 34

Powering
Trusted Identities
Regulatory
UL
Connect only to a Listed Access Control / Burglary LPS power supply. These readers are intended to be used with listed
(UL294) control equipment. Suitable for outdoor use.
Only Wiegand and Bluetooth communications have been evaluated by UL.
The Open Collector Output has not been evaluated by UL.
Inputs (reserved for future use) have not been evaluated by UL.
The Ethernet connection is for supplemental use; the unit is connected to an Access Control Panel.
The Signo Biometric Reader 25B is compatible with HID Mobile Access® version 3.3.1 and later using mobile devices with
BLE version 4.2 and later listed at:
https://www.hidglobal.com/mobile-access-compatible-devices
Install in accordance with NFPA70 (NEC) Local Codes, Canadian Electrical Code CSA 22.1, and authorities having
jurisdiction. Follow all National and Local Codes.
UL 294 Performance Levels
ACCESS CONTROL
MODEL # LINE SECURITY
25B
CE Marking
HID Global hereby declares that these proximity readers are in compliance with the essential requirements and other
relevant provisions of Directive 2014/53/EU.
Por el presente, HID Global declara que estos lectores de proximidad cumplen con los requisitos esenciales y otras
disposiciones relevantes de la Directiva 2014/53/EU.
HID Global déclare par la présente que ces lecteurs à proximité sont conformes aux exigences essentielles et aux autres
stipulations pertinentes de la Directive 2014/53/EU.
A HID Global, por meio deste, declara que estes leitores de proximidade estão em conformidade com as exigências
essenciais e outras condições da diretiva 2014/53/EU.
HID Global bestätigt hiermit, dass die Leser die wesentlichen Anforderungen und anderen relevanten Bestimmungen der
Richtlinie 2014/53/EU erfüllen.
HID Global dichiara che i lettori di prossimità sono conformi ai requisiti essenziali e ad altre misure rilevanti come
previsto dalla Direttiva europea 2014/53/EU.
Download copies of the Radio Equipment Directive (RED) Declaration of Conformity (DoC) at:
com/certifications
To ensure that RF exposure levels remain at or below the tested levels, a minimum safe separation distance of 10 mm
between the user and the reader is required for RF exposure compliance.
FCC
This device complies with part 15, subpart C, of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation. These limits are designed to provide reasonable protection against
harmful interference. This equipment generate, uses and can radiate RF energy and if not installed and used in
accordance with instruction, may cause harmful interference. Possible solution include: relocate the device, increase
separation between equipment, power equipment separately, consult with your dealer.
CAUTION: Any changes or modifications to this device not explicitly approved by HID Global could void your authority
to operate this equipment.
Canada Radio Certification
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
PLT-04027, Rev. B.1
All manuals and user guides at all-guides.com
DESTRUCTIVE
ATTACK LEVEL
LEVEL
Level I Level I
ENDURANCE
LEVEL POWER LEVEL
Level IV
34
HID® Signo™ 25B Installation Guide
STAND-BY
CONDITIONS
Level I
http://www.hidglobal.
October 2020