Pack Contents - Buffalo FT691 Manual De Instrucciones

EN

Pack Contents

The following is included:
• BUFFALO Bain Marie
• Pans 2 x 1/3 and 2 x 1/6 (FT691/FT692 only)
• Support bars (FT691/FT692 only)
• 5.2 litre pots x 2 (FT695 only)
• Instruction manual
BUFFALO prides itself on quality and service,
ensuring that at the time of unpacking the contents
are supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your BUFFALO dealer immediately.
Operation
Power switch Thermostat Dial
1. Connect the appliance to the power supply.
2. Fill the tank with water to a level between the
'MIN' and 'MAX' marks on the inside of the
tank.
Note: BUFFALO recommend that fresh
water should be used each time.
3. Switch the power switch to the On position [I].
4. Turn the thermostat to the desired temperature
to heat-up the appliance. The heat indicator
light will turn on.
5. Once the appliance has heated the water, the
heat indicator light will turn Off.
6. Reduce the heat setting on the Thermostat to
maintain temperature.
4
FT691 to FT695_ML_A5_v1_20220428.indb 4 FT691 to FT695_ML_A5_v1_20220428.indb 4
Maintaining Water Levels
It is important to regularly check the water level in
the tank.
• Always keep the water level above the
'MIN' mark on the inside of the tank during
operation.
• Damage to the heating element can occur if
the tank boils dry and the element may have
to be replaced. This is not covered by the
BUFFALO warranty.
Heat Indicator Light
Emptying the Appliance
FT692/FT694 - Turn on the tap to drain the water.
Ensure a suitable container is used to collect the
water.
FT691/FT693/FT695 - Use a suitable container to
remove the water from the appliance.
Thermal Cut-Out Reset
This appliance is fitted with a Thermal Cut-Out
safety feature. Should the temperature exceed safe
levels the appliance will automatically cut power.
The thermal Cut-out switch is located on the rear
of the appliance. To reset the appliance after a
sufficient cool-down period:
1. Unscrew the reset switch cover.
2. Press the small reset switch down until it clicks,
using a blunt pointed instrument.
3. The appliance is now reset and can be used as
normal.
WARNING: Do not allow
the water to drop below the
'MIN' level during operation.
Otherwise, severe damage to the
heating element could result.
Note: Always switch the
appliance off and allow the
water to cool before emptying.
2022/4/28 09:46 2022/4/28 09:46