Publicidad
6
Back Panel (O)
Nail
B
• With a helper, place unit on its front, as shown.
• Position back panel (O), notch as shown, even with the bottom edge of bottom (B)
and pilot holes align with partition (E).
• Make sure panel (O) fi ts square and even side to side. If it doesn't, adjust unit into
square by pushing or pulling on one corner of the unit until back panel fi ts squarely.
• While nailing into pilot holes, take care to hammer nails in straight.
Back Panel adds stability to the unit.
It is important to nail into all pilot holes.
11
Publicidad
