Description Of The Unit; Preparation; Initial Startup; Operation - Vermop JETVAC SD 7 Manual De Instrucciones

Description of the unit

Illustration A
Fleece filter bag
1
Suction hose port
2
Suction hose
3
Type plate
4
Carrying handle
5
Hose holder
6
Cable clips
7
Mains cable
8
Suction head
9
Suction head lock
10
Steering roller
11
Dirt receptacle
12
Main switch
13
Hard surface/carpet switch
14
Floor nozzle
15
Suction pipe
16
Angle piece
17
Main filter basket
18
Motor protection filter
19

Preparation

1. Unpack the device and install the accessories.
Illustration B

Initial startup

1. Check if the main filter basket is inserted in the de-
vice.
Operating modes
1 Operation with the filter bag
2 Operation without the filter bag
Installing the filter bag
1. Unlock and remove the suction head.
2. Remove the main filter basket.
3. Fit the fleece filter bag.
4. Insert the main filter basket.
5. Fit and lock the suction head.

Operation

Switching on the device
1. Connect the mains plug.
2. Switch on the device at the main switch.
Cleaning mode
1. Set the floor nozzle switch to hard surface or carpet.
2. Perform cleaning.
Switching off the device
1. Switch off the device at the main switch.
2. Pull out the mains plug.
Each time after use
1. Empty the container.
2. Vacuum off the inside and outside of the device and
clean with a moist cloth.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during transporta-
tion.
1. When transporting the device in vehicles, secure it
to prevent it from slipping or overturning in accord-
ance with the respective valid guidelines.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during storage.
The device may only be operated indoors.

Care and service

DANGER
Danger of electric shock
Injuries due to touching live parts
Switch off the device.
Remove the mains plug.
Cleaning the main filter basket
ATTENTION
Danger from wet main filter basket
Risk of damage to the device
Never insert the main filter basket when wet.
1. If necessary, clean the main filter basket (washable)
under running water.
Replacing the motor protection filter
1. Unlock and remove the suction head.
2. Remove the motor protection filter.
3. Fit the new motor protection filter.
4. Fit and lock the suction head.

Troubleshooting guide

DANGER
Danger of electric shock
Injuries due to touching live parts
Switch off the device.
Remove the mains plug.
The device stops during operation
The motor thermo-protector has triggered
1. Changing the fleece filter bag.
2. Replace the motor protection filter.
3. Check all parts for clogging.
4. Allow the engine turbine to cool for approx. 30-40
minutes. Switch on the device.
Suction turbine does not start up
1. Check the socket and the power supply fuse.
2. Check the mains cable and the mains plug of the de-
vice.
3. Switch on the device.
English

Transport

Storage

7