Hama 223401 Instrucciones De Uso página 5

Unless different instructions have been expressly
given in the operating instructions for the devices
you are charging, proceed as follows:
• Without connecting it to the socket, determine the
mechanical compatibility between the universal
power supply unit's adapter and the connection
socket on the device.
• Observe the polarity of the connection socket on
the device and plus the adapter in accordingly
(see Fig. 2).
• Set the voltage selector switch to the voltage
required by your terminal device. Do not change
the voltage again during operation of the power
supply unit in combination with a terminal device.
• Plug the universal power supply unit into the
socket provided for it.
• The terminal device can now be used and
switched on.
The product has replaceable fuse. Always replace
this fuse with the same type of fuse with the same
electrical values (see Fig. 3).
Note on connection to possible devices
• Before connecting a device, check that this
can be
supplied su ciently with the power supply
unit's current output.
• Check whether the device intended for
mains operation is compatible with the pin
assignment of the universal power supply unit.
If necessary, ask the dealer who supplied your
terminal device or contact your terminal device
manufacturer's support service.
Note - car battery
With some vehicles, it can happen that power
continues to be supplied even though the ignition
has been switched off. You should therefore
disconnect the product from the line connection
when not in use to protect your car battery from
being drained.
5. Care and maintenance
• Only use soft, dry towels to clean the product.
Note
Disconnect the device from the mains before
cleaning and during prolonged periods of
non-use.
6. Technical data
Car power supply unit
Input
Output current
Output voltages (DC)
Replaceable fuse
7. Warranty disclaimer
Hama GmbH & Co KG assumes no liability and
provides no warranty for damage resulting from
improper installation/mounting, improper use of
the product or from failure to observe the operating
instructions and/or safety notes.
12–14 V
1000 mA max
1.5 – 3.0 – 4.5
– 6.0 – 7.5 – 9.0
– 12.0 V
2 A
3