Working Advice - Bosch UniversalGardenTidy Manual Original

14 | English
Operating (see figures K, L and M)
Beware of trip hazards such as the supply cable or unatten-
ded product. Make sure that the cable is not in your way
while working. Fasten the cable in the cable holder on the
side of the auxiliary handle. (see figure K)
To switch on, turn the On/Off switch (1) clockwise until it
clicks.
The airflow speed is variable. To increase the airflow speed,
turn the On/Off switch (1) clockwise.
To reduce the speed, turn the On/Off switch (1) anticlock-
wise.
Direct the vacuum tube towards the debris that you want to
collect. If no debris is collected/moved, increase the airflow
speed.
To switch off, turn the On/Off switch (1) anticlockwise until
it clicks.
Set the On/Off switch (1) of the product to "0" before dis-
connecting the mains voltage or pulling the mains plug.
Disassembling (see figures N and O)
Before carrying out any work on the product, discon-
u
nect supply cord from the mains.
To empty the collection bag (10), press button (11) and re-
move the collection bag (10). Remove the clips from the va-
Troubleshooting
Problem Possible Cause
Product does not run Components not assembled correctly, safety in-
terlock activated
Power turned off
Mains socket faulty
Extension cable damaged
Fuse faulty / blown
Motor protector has activated
Product runs intermit- Extension cable damaged
tently
Internal wiring of product defective
On/Off switch defective
Motor protector has activated
Excessive vibrations/ Product defective or blocked
noise
Product does not blow/ Tube obstructed
vacuum
F 016 L94 484 | (20.07.2022)
cuum tube (7). Open the zip and empty the collection bag
(10) as required.
To disassemble, press button (11) and remove the collec-
tion bag (10). Remove the clips from the vacuum tube (7).
Take care not to pinch your fingers during disassembly.
Loosen the fastening screw (3). Remove the vacuum tube
(7) and store it securely.

Working Advice

When operating, always point the nozzle/vacuum tube to-
wards the ground.
Do not blow hot, flammable or explosive material.
The product is only suitable for foliage and garden waste.
Please inspect the area for little animals and hard objects be-
fore using the product.
Do not vacuum liquids, plastic bags, cans, pine cones,
branches larger than 5 mm (Ø > 5 mm), cloth, tissues and
pegs.
The motor will only start, if the following parts are assembled
correctly:
– vacuum tube and collection bag in vacuum mode
– nozzle and safety cover in blow mode
Corrective Measure
See "assembly". Check that the tube and the
safety cover (Blow Mode) or the tube and the col-
lection bag (Vacuum Mode) are fully assembled,
clicks are heard.
Turn power on.
Use another socket.
Inspect cable, replace if damaged.
Replace fuse.
Allow motor to cool down and check that fan is
not blocked.
Inspect cable, replace if damaged.
Contact Service Agent.
Contact Service Agent.
Allow motor to cool down and check that fan is
not blocked.
Check the fan area for debris and clean if neces-
sary. Contact Service agent if no difference iden-
tified.
Clear tube.
Bosch Power Tools