Publicidad
Idiomas disponibles
Idiomas disponibles
Manual
MS Automix 40
1.
Safety precautions.
•
Read the user's manual before using the machine.
•
The machine starts up automatically; avoid contact with moving parts or parts that can start moving.
•
The machine can be brought to a standstill immediately by pressing the emergency stop button.
•
The machine has a plug with an earth pin. Satisfy yourself that the earth circuit in your electrical installation is in
good order. Use a group provided with a residual current operated circuit breaker with an activation current of
30mA maximum. The machine works on 230V.
•
For all activities with the exception of adjustment and filling, first take the plug out of the socket.
•
Use a high-pressure spray only for cleaning the trough. Avoid the use of a high-pressure spray for cleaning the
control box; use a damp cloth for this.
•
Only use the correct fuses. The ratings are indicated next to the relevant fuse holders.
•
Make sure that the water hose and electrical flex are kept out of reach of the piglets.
•
Never use the device if the electrical flex is damaged.
•
Call in a specialist to repair any damage or to remedy any fault.
2.
Responsibility.
•
Wit-Mambo is not responsible for any damage or injury caused as a result of not or not properly following the
instructions in the user's manual.
•
Regarding items supplied Wit-Mambo is not responsible for damage compensation in any form whatsoever except
for compulsory legal regulations to do with product responsibility.
•
Dutch law is applicable to all goods and services supplied by us.
3.
Machine.
•
The machine provides the same quantity of feed each time. You can set the number of times this happens using
the 'feed quantity adjustment knob'. The consistency of the mash can be adjusted continuously using the 'water
flow regulator'.
Emergency stop; press to stop the machine, turn to the right and allow
to come up to start the machine again.
Feed quantity adjustment knob; turn to the left for more feed and to the right for less feed.
4.
Installation.
•
Fit the fixing supports and place the machine in the desired position. Put the lower side next to the walkway and
the side with the controls away from you. In this way filling and adjustment are easiest.
•
The machine can be bolted down through the grooves at the ends of the fixing supports.
•
Insert the end of the mixing blade into the eye at the end of the feed mortar.
•
Install the mixing chamber using the knurled knobs.
•
Attach the water hose by pushing it into the flow regulator coupling.
•
Connect the other end of the water hose to a water supply. Ensure the water is clean and the pressure is at least
0.5 bar (7 psi).
•
The machine starts automatically as soon as the power is switched on.
N.b. 3. and 4. will have been done already at delivery.
8
MS Automix 40
Water flow regulator; turn to the left for more water and to the
right for less water.
Fuse holder
Test button.
Publicidad
