Publicidad
Idiomas disponibles
Idiomas disponibles
Drill Rig:
§
Always keep the drill rig clean, especially the column with the toothing
and the 4 sliding pieces in the mounting plate. In order to allow the free
movement of the pinion shaft it should be slightly lubricated.
§
In order to achieve a good performance of the drill rig, the 4 sliding pieces
in the machine holder have to move along the column without backlash.
If the position has changed, it can be readjusted as follows:
Our after-sales service responds to your questions concerning maintenance
and repair of your product as well as spare parts.
EIBENSTOCK's application service team will gladly answer questions
concerning our products and their accessories.
Environmental Protection
Raw material recycling instead of waste disposal
In order to avoid damages on transportation, the power tool has to be
delivered in sturdy packing. The packing as well as the tool and its
accessories are made of recyclable materials and can be disposed
accordingly. The tool's plastic components are marked according to their
material, which makes it possible to remove environmental friendly and
differentiated because of available collection facilities.
§ Loosen the counter nut on the Allen
screw by means of a jaw wrench
SW17
§ Adjust the Allen screws and the
position of the thrust piece to the
column by means of a hex head
wrench.
§ Tighten the counter nut again and
checkwhether the carriage moves
easily on the column.
28
Publicidad
