Publicidad
TEMPERATURE PROGRAMMING.
Set point "initial temperature":
Press "up" and display appear initial temperature.
Mantenga presionado "arriba" 3 segundos, y puede comenzar: El valor de temperatura
digital está intermitente. Puede configurar la temperatura con las teclas hacia arriba y
hacia abajo
Set point "stop temperatura"
Press "down" and display appear the temperature of finalization.
Press "Down" 3 seconds. The finalization of temperatura appear flashing in display.
Set point temperatura with button Up/Down.
Restart:
Press "Up"/ "Down", The display indicate "888" and automatically run detection
temperature.
Codes:
P0 – Set point initial temperature: Press button "Configuration", display appear P0. Press
button "Configuration". Use button up/down for indicate the initial temperatura.
P1 – Set point stopped temperature: Press button "configuration", Display appear P0, use
button up/down for change to P1. Press button "configuration". Use button Up/Down for
indicate "stopped temperature".
P2 - Set point "correction of temperatura": Press button "Configuration". Display appear
P0. Use button Up/down for pass to P2. Press button "configuration" again for indicate the
calibration of temperatura with button Up/Down.
In programming, if the temperatura detected is 0.5 ° mor big than real temperatura The
correction of temperatura must to be -0.5 ° C.
P0 Run temperature
P1 Stopped temperature
P2 Correction temperatura
P3 delay start
-50 a 110 ° C 00.
-50 a 110 ° C 00.
-10 a 10 ° C 00.
0 a 10 min 0min
8
Publicidad
