Zeiss Colibri 5 Manual Breve página 12

ZEISS
11 HOW TO GET TO THE FIRST PICTURE
Colibri 5/7 has been mounted on the microscope and powered via the desktop power supply unit.
The control panel is connected to the Colibri 5/7.
The microscope has been switched on.
Fig. 4 Control panel for Colibri 5/7
• If several LEDs have been switched on, press the control dial shortly until the LED button of the desired
LED flashes. The LEDs which are switched on can be switched through by shortly pressing the control
dial.
• Set the desired brightness for the activated LEDs using the control dial on the control panel.
The brightness setting is updated synchronously on the display.
• To adjust the brightness control of all LEDs switched on simultaneously press the
(Fig. 4/4).
All LEDs which are switched on will flash.
12 SWITCHING OFF SAFELY
• Unplug the mains plug from the table power pack.
• Before covering the light source and the microscope used, switch off the microscope and allow the
fluorescence illuminator to cool down.
10
HOW TO GET TO THE FIRST PICTURE
• Open the reflected light path shutter on the
stand, if required.
• Switch on the desired LED by shortly pressing
the corresponding LED button (see Fig. 4/5),
e.g. UV LED button.
The LED button lights up. On the display (Fig. 4/1),
the current brightness value is shown as a
percentage to signal that the LED is switched on.
• If required, switch on further LEDs by pressing
the corresponding LED buttons (up to 6 LEDs
simultaneously).
• Activate the brightness adjustment for an LED
by pressing the control dial (Fig. 4/6) shortly
downwards.
The LED which is switched on and activated for
brightness adjustment will flash. The LED which
has been activated for brightness adjustment will
be marked with a circle (Fig. 4/2) left of the letter.
423052-6044-008
Colibri 5/7
button
09/2017