Change Lamp - brennenstuhl Power Jet-Light 4 x 36 W Instrucciones De Uso

Power Jet-Light 4 x 36 W IP54
6.2

Change lamp

DANGER:
Disconnect mains plug before opening the working lamp!
Let working lamp cool down before touching it (at least 15 minutes).
Any contact might cause burns.
Step Operation
1 Turn working light on the "back". Press rubber lip down.
Figure 3: Remove rubber lip
2 Unscrew the 4 screws of the protective cover from casing. Remove protective
cover.
Figure 4: Open protective cover
3 Remove lamp from socket by pulling it upwards.
Figure 5: Socket
4 Insert new lamp with light pressure.
5 Put protective cover on the casing. Screw the 4 screws of the protective cover into
the protective cover. Put sealing over protective cover again.
IMPORTANT: See that the sealing sits correctly between casing and
protective cover.
Instruction manual
Pos. Description
7 Protective cover
8 Rubber lip
13 Casing
Table 4: Remove rubber lip
Pos. Description
13 Casing
15 Protective cover screws
Table 5: Open protective cover
Pos. Description
6 Socket
9 Lamp
Table 6: Socket
16 GB