Retention System - Nolan N60-6 Instrucciones

N60-6
WARNING
- Before using the helmet read this booklet and all enclosed documents carefully, in that they
contain very important indications on how to use the helmet easily and safely. We recommend
you to store it for future reference.
- Failure to observe these instructions may reduce the protection provided by the helmet and
consequently put your safety at risk.
- Do not operate or act in such a way that could compromise or reduce the protection provided
by the helmet.
CHOICE AND VERIFICATION OF HELMET
WARNING
To exploit the whole protection offered by the helmet, choose the correct size for your
head, adjust the retention system correctly and check the taking off.
1 SIZE
1.1 In order to determine the correct helmet size, try on helmets of different sizes and choose the
one which suits best the shape of your head and which you feel firm once worn and fastened,
thus ensuring a great comfort.
1.2 Should the helmet be too big, it may slide down to cover the eyes or turn slowly to the side
while riding.
1.3 Keep it on for a few minutes and make sure there are no points of extreme pressure that may
cause pain or headache.
2

RETENTION SYSTEM

2.1 The retention system (strap) is factory-adjusted at a standard length. Before use (see relevant
instructions) check that it is correctly pre-adjusted.
2.2 Make sure the strap is properly fastened and tightened so as to keep the helmet firmly in place.
Anyway, before riding, make sure that the strap is well fastened under the chin, as close as
possible to the throat, but without being uncomfortable.
2.3 The correct strap tension should allow normal breathing and swallowing, but without leaving
the space of a finger between strap and throat.
WARNING
The button which may be present on the strap only prevent its end from flapping once
the strap has been fastened properly.
3 TAKING OFF
3.1 With the helmet on and the strap securely fastened, try to take the helmet off as shown in fig-
ure (A). In case of accident, the different forces at stake and their various directions may result
in helmet rotations or they may even cause the helmet to take off if it is not securely fastened.
3.2 The helmet should not rotate nor move on the head and should not slide off. Should the con-
trary happen, adjust strap length or change helmet size. Repeat test.
USING THE HELMET
- The helmet is specifically designed for motorcycle and motorbike use. Therefore, it must not
be used for different purposes (or different reasons or operations) since, in such cases, it
would not guarantee the same protection.
- In case of accident, the helmet represents a protective element, which reduces injuries and
head damage. Nevertheless, no helmet can guarantee total safety. The helmet reduces the risk
or the gravity of injuries in case of accidents, but the degree of some impacts and the different
circumstances may exceed helmet protection. Therefore, ride safely.
12
SAFETY AND INSTRUCTIONS FOR USE