BE Power Equipment P1915EN Manual Del Operador página 8

ASSEMBLY INSTRUCTIONS
3
High Pressure Hose Assembly
Screw high pressure hose (D) clockwise onto bottom front
of power washer unit (A). Pull back collar and insert o-ring
post into water outlet far enough so collar can thread onto
outlet threads until hand tight. If it takes fewer than six
turns you have not properly tightened the high pressure
hose fitting. It is easier to position the power washer
in front of you to ensure that the threads are started
correctly. Failure to properly tighten high pressure hose
will result in the hose slipping or popping off immediately
upon turning unit on. Do not worry about damage if this
occurs–just reinstall and take extra care when screwing on
the high pressure hose fitting.
Note: DO NOT use pliers or locking pliers to tighten.
5
I
3
D
2
Twist collar then pull back to release the the high
pressure hose (D) connection from the gun (I).
8
A
D
1
3
D
4
I
D
1
Pull back on collar at the other end of the high pressure
hose (D). Push firmly to connect hose to spray gun (I).
Twist collar to secure. Confirm hose is locked into spray
gun by slightly pulling on them. The hose is now
securely attached to spray gun.
6
1
Unlocked
Locking Spray Gun (Before Lance Installation)
To lock trigger of spray gun (I), point gun away
from you and turn dial to lock ("3" and "9" position).
Squeeze or pull trigger to make sure it is locked.
ALWAYS leave in locked position when not in
use. This ensures the gun is in "safe" mode until it
is ready for use. Turn dial to unlock ("12" and "6"
position) to release spray gun trigger.
Note: The trigger lock prevents trigger from being
accidentally engaged.
bepowerequipment.com
2
3
D
I
Locked