Maintenance And Cleaning - UFESA NT3510 Manual De Instrucciones

NOSE TRIMMING (Fig. 2)
In the nostril, swing the trimmer head from side to side with the tip of the trimmer head and
snip off the hairs around the entrance. After cutting off, there is still some hair residue in
the nostrils, please wipe off with a tissue.
COMPONENT REPLACEMENT METHOD (Fig. 3)
To switch the trimmer attachment, proceed as follows:
1. Switch off the device.
2. Hold the device, twist the trimmer attachment to the right and rotate anticlockwise the
trimmer attachment.
3. Pull the trimmer attachment up and off.
4. Place the nose trimmer blade onto the device from above, so that it sits completely on
the device.
5. Twist the nose trimmer blade to the left until it clicks into place and rotate clockwise the
trimmer attachment.

MAINTENANCE AND CLEANING

To clean the trimmer blade particularly thoroughly, you can rinse it under running water.
Turn the head of the device slightly to the right and remove the head. Hold the trimmer
blade under running water so that the stream of water runs over the razor blade. Leave the
trimmer blade to dry completely before you reattach it to the device.
Remove the batteries when you do not intend to use the product for an extended period of
time to prolong its shelf-life.
Do not forget to remove the interchangeable heads prior to putting them under water to
clean them, afterwards letting them dry prior to storage.
The device must be cleaned with a moist towel, and no chemical products must be used.