Publicidad
Idiomas disponibles
Idiomas disponibles
4. Repeat steps 1-3 for the opposite side of the wheelchair.
5. To release the front rigging, push the footrest release lever
inward, rotate footrest outward. To remove the front rigging,
lift and remove from hinge pins.
ANTI-TIPPER INSTALLATION
C
NOTE:
Ensure both anti-tippers are positioned to same setting.
ATTACHING SEAT EXTENDER
1. Remove tube end caps and u-clips from either side of the
wheelchair seat rails.
2. Take the seat extender attachment with Velcro side up and
align into corresponding seat rail tubes. Line up the holes on
the seat rails to the holes on the seat extension tubes.
3. Insert the u-clips and depress until fully locked onto the
seat rail.
4. Slide the Velcro upholstery extension under the seat
upholstery on the wheelchair to adhere to the matching
Velcro strip.
NOTE:
Ensure the extender is locked in place and secure
before putting to use.
ADJUSTING LENGTH OF FOOTREST/LEGREST
NOTE:
When adjusting length of footrests or legrests, user
should be sitting in wheelchair with feet on the footplates.
D
be so low that it causes uncomfortable pressure to thighs at
front of seat upholstery. Footrests should not be lower than
2 ½" from the ground to ensure proper clearance.
3. Once the desired length is found, ensure that both push pins
are securely locked in place. An audible click will be heard
when they lock in. Flip the locking clamp down into the
locked position.
4. Repeat steps 1-3 for the opposite side.
4
1.
Remove the anti-tippers from the
accessory box.
2.
Insert the anti-tippers with the wheels
curved down towards the ground/floor
until they lock back into place. You will
hear an audible click once locked (Fig. C).
3.
Repeat for other side.
1.
Flip up the locking clamp around the
support assembly (Fig. D).
2.
Raise or lower the footplate to desired
position by pressing thumb and index
fingers on the two push pins just above the
locking clamp. Front rigging should not
Publicidad
