Publicidad
Idiomas disponibles
Idiomas disponibles
BATTERY INSTALLATION
Spotlight
The spotlight requires four D size batteries (not supplied). For reliable, long-lasting
performance, use only high quality alkaline batteries. To install batteries:
1.
Turn the front cover of the spotlight counter-clockwise to the unlock position
Figure 1) to release and remove the cover.
2.
Insert batteries according to the polarity markings (+ and -) indicated inside the
battery compartment (see Figure 2).
3.
Align the
marks then turn the front cover clockwise to the lock position
secure the battery compartment (see Figure 3).
Figure 1
Remote Control
WARNING! This product contains a button/coin cell battery. If the button/coin cell battery is swallowed,
it can cause internal chemical burns in as little as two hours and lead to death. Dispose of used
batteries immediately. Keep new and used batteries away from children. If the battery compartment
does not close securely, stop using the product. If you think batteries might have been swallowed or
placed inside any part of the body, seek immediate medical attention.
Australia: If you think batteries might have been swallowed or placed inside any part of the body,
immediately call the 24-hour Poisons Information Centre on 13 11 26 for fast, expert advice and go
straight to the nearest hospital emergency room.
The remote control is powered by a CR2025 battery which comes pre-installed.
•
To activate the battery, simply pull the plastic film out from the bottom of the
remote control.
•
To replace the battery, remove the locking screw on the back of the remote control
using a small Phillips screwdriver, then push the tab on the left of the battery tray
towards the right and pull out the battery tray from the remote control (see Figure
4). Place a new "CR2025" battery on the tray with the positive (+) side facing up.
Insert the tray back into the remote control and secure with the locking screw.
Figure 2
Locking Screw
CR2025
Figure 4
(see
to
Figure 3
PUSH
EN
3
Publicidad
