Publicidad
Idiomas disponibles
Idiomas disponibles
Defining IP Camera Settings
Step 1
Your PoE supported camera can be used without electrical connection by using only the
Ethernet cable. To achieve this, connect one end of the Ethernet cable (LAN) to the camera
Ethernet port and the other side to:
1. A PoE injector that is connected to your network or
2. To a PoE supported router or switch.
Alternatively, your IP camera can also be powered by a RISCO supplied 12V DC adaptor.
Step 2
Log into the Installer Administration at www.riscocloud.com/installer.
Step 3
Once logged in, click Control Panels List → select the desired control panel →
click Network Cameras → click
the example below.
Step 4
Once the "camera is ready for use" message is displayed, click OK. The defined IP camera is
displayed in the IP Cameras page and ready for use.
and then fill the required fields as shown in
4
Define
Camera
Settings
Click when done
Please wait for
camera to connect
Publicidad
