ledscom LC-EL-078-W Instrucciones De Montaje página 5

1. Disconnect the building-side connecting
cable from the power supply and secure it
against being switched on again. To do
this, trip the corresponding circuit breaker
of the house installation.
Remove the light from the mounting pot
(Figure 1).
3. pierce or cut a cable opening in the
installation pot at one of the perforations
provided (Figure 2).
4. lead the power supply side connection
cable (Figure 3) through the opening just
created and place the mounting pot in its
mounting position.
5. Connect the connection cable of the
light to the connection cable on the power
supply side. To do this, hand-tighten the
screw seal (Figure 4).
6. now place the light in the mounting pot.
7. Turn the power back on. The installation
is now complete.
Subject to technical changes
LEDs Com GmbH, Dohrweg 2a, D-41066 Mönchengladbach, www.leds-com.de, Tel. +49 (0) 2161 - 5 75 99 76
English
Figure 1
Figure 3
Paving stone (LC-EL-078-W) - Assembly instructions
Figure 2
Figure 4
05/2022