Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING THE PRODUCT
♦ Pull the rear cover handle to remove it (FIG1)
♦ Remove the plastic package from the filter (FIG2)
♦ Install the filter into the machine (FIG3)
♦ Fasten up the rear cover and connect to the power
source (FIG4)
USE:
♦ The appliance can be used directly connected to the
main.
♦ Extend the cable completely before plugging it in.
♦ Attach the appliance to its base / connector making sure
that it is correctly fitted into place.
♦ Connect the appliance to the mains.
♦ Guide the appliance to direct the flow of air in the desired
direction.
♦ Turn the appliance on, by using the on/off button (4).
♦ Select the appliance function desired.
♦ Select the desired speed.
FAN SPEED MODE
Cycles through fan speeds:
MEDIUM
HIGH
TURBO
FILTER REPLACEMENT
♦ When the filter life expires (about 2000 hours of life time)
the light ring will blink red to remind you.
♦ Follow "installing the product" instructions
♦ After change the new filter, press and hold filter replace-
ment button (5) to reset.
♦ When the light ring flash in green three times, the filter
life span reset is complete.
LIGHT RING
♦ Press Light ring button (1), the light ring will keep one
color constantly, press this button again, the light ring will
start shifting color.
♦ While the light ring is on, press this button twice to turn
it off.
♦ While the light ring is off, press this button twice to turn
it on.
♦ Ambient light color cycle:
RED-BLUE-GREEN-YELLOW-PURPLE
Once you have finished using the appli-
ance:
♦ Select the minimum position (MIN) using the speed
♦ Turn the appliance off, using the on/off button.
♦ Unplug the appliance from the mains.
♦ Clean the appliance.
Safety thermal protector:
♦ The appliance has a safety device, which protects the
♦ When the appliance switches itself on and off repeatedly,
♦ If the appliance turns itself off and does not switch itself
CLEANING
NIGHT
♦ Disconnect the appliance from the mains and allow it to
♦ Clean the electrical equipment and the mains connection
♦ Clean the equipment with a damp cloth with a few drops
♦ Do not use solvents, or products with an acid or base pH
♦ Do not let water or any other liquid get into the air vents
♦ Never submerge the appliance in water or any other
♦ Do not wash the filter.
♦ Do not use a vacuum cleaner to clean the filter.
♦ Sterilize the filter under sunlight regulary.
♦ If the appliance is not in good condition of cleanliness, its
(Original instructions)
control.
appliance from overheating.
for reasons other than the thermostat control, check to
ensure that there are no obstacles that impede correct
air entry or expulsion.
on again, disconnect it from the mains supply, and wait
for approximately 15 minutes before reconnecting. If the
machine does not start again seek authorised technical
assistance.
cool before undertaking any cleaning task.
with a damp cloth and dry. DO NOT IMMERSE IN
WATER OR ANY OTHER LIQUID.
of washing-up liquid and then dry.
such as bleach, or abrasive products, for cleaning the
appliance.
to avoid damage to the inner parts of the appliance.
liquid or place it under running water.
surface may degrade and inexorably affect the duration
of the appliance's useful life and could become unsafe
to use.
ENGLISH
7
Publicidad
