Maintenance; General Maintenance - Ryobi RB101 Manual Del Operador

WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal injury.
Electric tools used on fiberglass material, wallboard, spackling
compounds, or plaster are subject to accelerated wear and
possible premature failure because the fiberglass chips
and grindings are highly abrasive to bearings, brushes,
commutators, etc. Consequently, we do not recommend using
this product for extended work on these types of materials.
However, if you do work with any of these materials, it is
extremely important to clean the product using compressed
air.

MAINTENANCE

LUBRICATION
All of the bearings in this product are lubricated with a
sufficient amount of high grade lubricant for the life of the
unit under normal operating conditions. Therefore, no further
lubrication is required.
POWER SUPPLY CORD REPLACEMENT
If replacement of the power supply cord is necessary, this
must be done by an authorized service center in order to
avoid a safety hazard.
APPLICATION AND BUFFING BONNETS
Both the application and buffing bonnets are reusable. For
maximum life and performance, hand wash after use and
allow them to air dry. If needed, the bonnets can be machine
washed in cold water with a small amount of detergent, then
machine dried using low heat.
FOAM PAD
It is important that the pad retains its original shape and
dimensions. Allow it to dry completely after each use.
Make sure to remove the bonnets, wash them, and store
separately. Polisher should be stored with the pad facing
up in order to extend pad life and retain its shape. Be careful
not to use too much polish at one time. If the pad becomes
saturated, it will not last as long.
MOTOR AND INTERNAL COMPONENTS
The motor and internal components are designed to be
maintenance free. The exterior surface can be cleaned with
a mild soap and damp sponge.
If you suspect a problem with the motor or other internal
components, do not attempt to remove the motor housing
or otherwise expose the internal components. Call
1-800-525-2579 for the authorized service center nearest you.
9 — English